![]() Part 2: Configure the IPv6 Addressing on Routers and PCs and Verify Connectivity Step 1: Configure the routers with IPv6 addressing. Note: This network is already configured with some IPv6 commands that are covered in a later course. ![]() ![]() Router(config-if)# ipv6 address ipv6-address/prefix #Ccna 3 8.3.1.2 packet tracer how toĪt this point in your studies, you only need to know how to configure IPv6 address on an interface.Ĭonfigure R1 and R2 with the IPv6 addresses you specified in the Addressing Table and activate the interfaces. Router(config-if)# ipv6 address ipv6-link-local link-local Step 2: Configure the PCs to automatically receive IPv6 addressing.Ĭonfigure the four PCs for autoconfiguration. #Ccna 3 8.3.1.2 packet tracer fullĮach should then automatically receive full IPv6 addresses from the routers. Step 3: Verify connectivity between the PCs.Įach PC should be able to ping the other PCs and the routers.Ĩ.4.1.Below are the following commands to solve this packet tracer, as well as a minor explanation as to why we use these commands. R1(config-if)#ip hello-interval eigrp 1 10 If there's an error here, use the report feature on the contact us page. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |